How Do You Clean A Whirlpool Bath?

Posted by wfleonard in The Sand and the Foam Blog

How Do You Clean A Whirlpool Bath?

The Old Way To Clean A Whirlpool Bath

The simple answer is to use a specially formulated Whirlpool bio cleaning cleansing solution, one such bio cleaner is manufactured as Ahh-Some Jetted Tub Bio Cleaner, a highly concentrated gel. Every week, after your Sunday Jetted Tub Bath you should leave the water (dirty) in the whirlpool bath and add the manufacturers required amount of Ahh-Some Jetted Tub Bio Cleaner to it. This is typically 1/3 teaspoon, a very small amount. Then switch on the whirlpool tub (ensure the air controller is off) for a period of 10 – 15 minutes. The bio cleaning gel runs through the piping system, and breaks down any detritus, for which we refer to as gunk, that has accumulated … and there may be quite a lot … so don’t be so alarmed. Once this is done, drain the whirlpool bath, wipe the ring around the tub. There is really no need to refill the whirlpool tub, just a waste of water, as the bio cleaner is safe enough to bath in, but it continues working in your pipes.

We are the “New School” of cleaning, breaking down detritus, and destroying the bacteria, leaving a healthy bathing atmosphere for you.

Be Sociable, Share!

•